Mimolite wiring diagram for garage door application.
Smartthings mimolite garage door.
I have mimolite garage door controller set as the device type.
Initially i got the solution that johnconstantelo developed working with a magnetic switch that triggered when the door closed.
I have a set up a mimolite to open and close a garage door.
A switch on the door tells mimolite the current door status open or closed.
The mimolite garage door device type will allow me to open and control the garage door in the things section although the state is not correct and the configure button does nothing.
The tile in my device type actuates the mimolite to open close the door but it doesn t reflect the state of the door so i created a virtual.
Mb323 i wish i would have seen this thread earlier because i wrote one a long time ago that i ve been using that i could have shared it uses the magnetic contact similar to post 3 above and it also notifies if when the mimolite looses power.
In the routine.
I was hoping to make changes to how this works for my case as i want it to control a gate.
See mimolite for garage door and magnetic door contact this worked find except sometimes the close open event would get missed.
Mimolite installation instructions for vera controllers.
Mimo2 installation instructions.
In doors and locks i can get it to show me the correct state i m just using a smartthings open close sensor however tapping the button does nothing.
Flow meter guide with homeseer.
Next i set up a routine to turn on the garage light and open the garage door.
Mimolite installation guide for smartthings.
Flow meter guide with smartthings.
So far this is what i ve done.
If i go to the ide and add a device by selecting from template and then select mimolite garage door controller the code doesn t load or show up like other devices.
I don t know if this is linked to current reports.
Mimolite wiring diagram for apollo gate opener.
In the things menu i can read the current door status as well as open and close the door.
